Sensus water meter reading diy home assistant

#Sensus water meter reading diy home assistant how to

Use caution with the length of the wires to your sensors. If you go over 4 sensors then you will need to remove the 100 ohm pull-down resistor and change it to 500 ohm to 1K ohm instead. By default you can add about 4 sensors in parallel without changing the resistors on the sensor board. That is all there is to do!Д«TW - If you want or need to monitor multiple sources of water from one NodeMCU you can parallel the water sensors. Finally the A0 (Analog channel 0) pin of the NodeMCU is wired to the Sensor (S) pin. The 3.3V pin from the NodeMCU goes to the PLUS (+) pin of the sensor. The ground (-) from the NodeMCU goes to the minus connection on the sensor. There are only three wires that need to be connected. A 5V USB power source and a USB micro cable

#Sensus water meter reading diy home assistant how to

The Arduino IDE with the NODEMCU enabled (see other Instructables on how to setup the IDE for this board)Д¦. I used a WeMos Mini or a NodeMCU type boardДЈ.

We will go into some detail in this instuctable but a good starting point is to create an account and have a look around.Дў. This is a free Internet of Things web interface that will collect your water leak devices data and format various alerts based on the data. In addition you will be able to log into a account and observe live readings and trends to see if a potential leak may be happening.ДЎ. This instructable will show you how to create an inexpensive water leak detector that can connect to your home's WiFi router and can send you a text or email if it detects a leak. Most of these leaks are from hot water heater tanks that spring a leak, faulty water pipes, flooding, or air conditioning units that do not drain properly. According to the average water damage repair bill is around $2438 in US dollars. Have you ever had a water leak in your home that went un-noticed until damage was done? Sadly this type of problem happens all too often.